Iphone lightning connector repair3/20/2024 ![]() ![]() The iPhone Xs is built in the same way and is re-glued in the same way. Then carefully bend all flex cables to the side and remove the logic board.Then unlock the SIM card holder and take it out.They connect for example the charging socket, the flashlight and the volume keys. Then disconnect all other contacts from the logic board.If you can't get any further with a Spudger, you can also lever very carefully with tweezers or another thin tool. The contacts are very firmly connected to the logic board and are not easily accessible. Loosen the two contacts carefully with a spudger.Remove the Standoff screw and loosen the cover.There are also special screwdrivers with a cross profile and a pin in the middle. For the screw with internal thread, also called Standoff screw, you can use a thin slotted screwdriver. Two of the contacts on the logic board are still under a cover plate. Once all the adhesive strips are off, you can remove the battery.Try to bend the battery as little as possible.įirmly hold the battery and iPhone while pulling out the last adhesive strip to prevent the battery from falling out of the device. If one of the adhesive strips tears, you have to pry out the battery carefully using a wide Spudger. Make sure not to damage any flex cables at the bottom and top edge of the battery. How to do this is best seen in the video (play button in the upper right corner of the first picture). You can pull out the adhesive strips with your fingers or wrap them on the tweezers.Keep the strips as flat as possible at the level of the iPhone. Now pull out the adhesive strips very slowly.Underneath are the white adhesive strips. Use tweezers or a spatula to peel off the black tabs. ![]() ![]() Three tabs are glued to the bottom edge and one strip to the top edge of the battery. The adhesive strips have tabs to pull them out. The battery is glued to the case with four adhesive strips. Heat the outer edge of the frame several times if necessary. Rest the display on a stable object to avoid straining the sensitive flex cables. Then you can fold the display over to the side.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |